Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!usc!brutus.cs.uiuc.edu!ux1.cso.uiuc.edu!ux1.cso.uiuc.edu!uxa.cso.uiuc.edu!bty00298
From: bty00298@uxa.cso.uiuc.edu
Newsgroups: comp.sys.amiga
Subject: Re: 2630 Problems
Message-ID: <46200037@uxa.cso.uiuc.edu>
Date: 28 Feb 90 10:39:27 GMT
References: <25@<129>
Lines: 23
Nf-ID: #R:<129:25:uxa.cso.uiuc.edu:46200037:000:1008
Nf-From: uxa.cso.uiuc.edu!bty00298    Feb 27 13:18:00 1990


I have had my A2630 for about three months now and it has worked great
with Sculpt 4D.  I've done some pretty interesting traces and animations
that were pretty complex without a problem.  I haven't used the other two
programs, but AmigaWorld tested the A2630 on Turbo Silver 3.0.  My only
guess would have to be a possible conflict with the 2630 and the 2091.
This problem manifests itself when the system boots since there is an
auto-config problem.

Commodore has issued new ROMs for the 2630, 2091, 2088, and the 2286.
This upgrade was used when my 2088 stopped working with the 2630, but
unfortunately the problem has not cleared.

This doesn't sound like the source of your problem, but it might help to
know exactly how these programs fail?  If you get crashes a lot then I would
say check on the ROMs.

Hope this has been of some help.

=============================================================================
Brian Yamanaka
University of Illinois at Urbana-Champaign
bty00298@uxa.cso.uiuc.edu