Path: utzoo!censor!geac!torsqnt!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!rutgers!texbell!texsun!newstop!sun!imagen!atari!portal!portal!cup.portal.com!John_A_Pham
From: John_A_Pham@cup.portal.com
Newsgroups: comp.sys.apollo
Subject: Re:  Various hardware hackins with DN420
Message-ID: <27536@cup.portal.com>
Date: 4 Mar 90 09:16:32 GMT
References: <9003021407.AA18053@richter.mit.edu>
Organization: The Portal System (TM)
Lines: 14

Since my hard disk on the DN600 crashed, and I have no way of reformating using the monitor (MD).
But my DN420 is now in working order (thanks to M. Lohmeyer for his hints),
I wonder if I were disconnect the cable on the Priam hard disk board (DN600) and
install another 50 pins cable at location J1, then install the other end
to the Priam HD cntrl board at location J2 (DN420), then 
reset my dead hard disk drive selection switch to 2......when this is done,
can I reformat drive 2?  Can Aegis/Domain v9.6 able to handle another hard
disk?
 
If you have any hints or tips, please send them to me
Thanks,
John
 
Ps...Is Priam 15450 SASI compatible?