Path: utzoo!attcan!uunet!aplcen!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!swrinde!cs.utexas.edu!milano!cadillac!sigsun!sid
From: sid@sigsun.cad.mcc.com (Sid Sidhartha)
Newsgroups: comp.sys.ibm.pc
Subject: AMI BIOS Setup Question
Message-ID: <6512@cadillac.CAD.MCC.COM>
Date: 2 Mar 90 14:24:16 GMT
Sender: news@cadillac.CAD.MCC.COM
Reply-To: sid%cad@MCC.COM (Sid Sidhartha)
Distribution: comp.sys.ibm.pc
Organization: MCC CAD Program, Austin, TX
Lines: 14

I had bought a no-name clone 386/20 with 1M and recently upgraded it with
another 1M.  After I installed the extra 1M and powered up the machine, I was
told to run the set-up routine.  

Right now, the machine recognizes the extra 1M, but, on my confgiguration table
it still tells me that banks 2/3 are disabled.  What gives?  How do I set it up
so that it tells me that banks 2/3 are enabled with 256K DRAM chips?  The setup
instructions weren't too clear about this.

regards,
sid
-----------------------------------------------------------------------------
Sid Sidhartha, MCC CAD  | ARPA: sid%cadillac@mcc.com | Phone: [512] 338-3343
 Box 200195, Austin, TX 78720 | UUCP: ...!cs.utexas.edu!milano!cadillac!sid