Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!usc!samsung!umich!vela!bbesler
From: bbesler@vela.acs.oakland.edu (Brent Besler)
Newsgroups: comp.sys.ibm.pc
Subject: Re: programs crashing in Desqview
Message-ID: <204@vela.acs.oakland.edu>
Date: 2 Mar 90 18:33:14 GMT
References: <48e591a9.20b6d@apollo.HP.COM> <29312@amdcad.AMD.COM> <9631@portia.Stanford.EDU>
Reply-To: bbesler@vela.acs.oakland.edu (Brent Besler)
Distribution: usa
Organization: Oakland University, Rochester MI
Lines: 13

I have found Desqview 386 to be OK, but it is very handy to have a hardware
reset switch handy when using it. I have found that any parameters on the
device=qemm.sys line in my config.sys file causes a "Internal Stack Overflow
System Halted" error which is only recoverable by a hardware reset.  I have
a Jameco 386/20 board with an AMI bios running IBM DOS 3.31.  Removing
everything from the config.sys files and autoexec.bat files except the
qemm line still causes crashes if any parameters are on it.  Has anyone out in
netland experiences such problems with Desqview.  With no parameters QEMM and
Desqview work fine.  I would like to use DV to load TSR programs into high 
memory, but the requires the RAM parameter on the qemm.sys line in config.sys.

                                            Brent H. Besler