Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!usc!ucsd!ucsdhub!hp-sdd!ncr-sd!ncrlnk!ncrcce!pasek
From: pasek@ncrcce.StPaul.NCR.COM (Steve Engelhardt)
Newsgroups: comp.sys.mac
Subject: Re: Apples Macromaker
Summary: There IS an easier way....
Keywords: MacroMaker
Message-ID: <1938@ncrcce.StPaul.NCR.COM>
Date: 28 Feb 90 17:24:05 GMT
Expires: 9 Mar 90 05:00:00 GMT
References: <20918215MES@MSU> <14080@phoenix.Princeton.EDU>
Reply-To: pasek@c10sd3.StPaul.NCR.COM (M. A. Pasek)
Followup-To: comp.sys.mac
Distribution: na
Organization: NCR Comten, Inc.
Lines: 16

In article <14080@phoenix.Princeton.EDU> englandr@phoenix.Princeton.EDU (Scott Englander) writes:
>Simply change the current macro set in use in the MM dialog, load each
>macro, then change back to the new macro set and save.  You'll have to
>do this for each one.

There's a much easier way to do this (which I e-mailed to the original poster):
Open your old macro set.  Select (click to highlight) the first macro you 
want to move.  Shift-select subsequent macros.  "Copy" (you have to use
Command-C, as the menu is disabled during MacroMaker's "dialog").  Switch
to new macro set. "Paste" (again, Command-V: no menu).  You've just copied
all your macros from the old set to the new -- I actually thought this was
intuitively obvious to the casual (Mac)Observer.....    ;-)

M. A. Pasek               Software Development              NCR Comten, Inc.
(612) 638-7668              MNI Development               2700 N. Snelling Ave.
pasek@c10sd3.StPaul.NCR.COM                               Roseville, MN  55113