Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!doe.UToronto.CA!tak
From: tak@doe.UToronto.CA (Tak Ariga)
Newsgroups: comp.sys.xerox
Subject: 1108 stuck at MP0900
Message-ID: <90Mar1.232256est.6427@neat.cs.toronto.edu>
Date: 1 Mar 90 18:46:27 GMT
Sender: welch@tut.cis.ohio-state.edu
Distribution: inet
Organization: Info-1100
Lines: 20

Our 1108 (running Medley) gets stuck at MP0900 after a 1-boot.  The diagnostic
floppy says everything is ok.  I have repartitioned and reinstalled the
software, but the problem persists.  I'm convinced that it is a hardware
problem, but the local Xerox (hardware) support people say that if it passes
the diagnostic, it must be the software that is to blame, and won't send out
a technician to fix it.  I'm quite sure that a board is bad, but I don't want
to swap them all to determine which one it might be.

Has anyone had a the same or similar problem?  Does anyone know what might
be wrong?

Thanks.

--Tak

_____________________________________________________________________________
uucp:      ...!uunet!attcan!utzoo!utdoe!tak  |  Tak Ariga, Programmer
Internet/BITNET:        tak@doe.utoronto.CA  |  The Dictionary of
non-domain BITNET:(last resort) TAK@UTORGPU  |          Old English Project
Phone:                      +1 416 978 8883  |  University of Toronto, CANADA