Xref: utzoo comp.unix.xenix:10418 comp.unix.i386:3325
Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!samsung!xylogics!merk!alliant!linus!nixbur!nixpbe!peun11!nerv
From: nixpbe!nerv@peun11.padp (RV-Intallation Struewer,Elke,ET2,Tel.6156)
Newsgroups: comp.unix.xenix,comp.unix.i386
Subject: Re: Western Digital WD8003EB with SCO UNIX 3.2
Keywords: ethernet, tcp/ip, wd8003EB
Message-ID: <1344@nixpbe.UUCP>
Date: 5 Mar 90 11:24:31 GMT
References: <593@kivax.UUCP>
Sender: news@nixpbe.UUCP
Followup-To: comp.unix.xenix
Lines: 29

cmc@kivax.UUCP (Crampton) writes:

>I am having problems getting SCO TCP/IP with SCO UNIX 3.2.0 to work
>using the Western Digital WD8003EB ethernet controller.

>Is there anyone out there who is successfully using one of these cards
>with SCO UNIX?

We use this ethernet controller successfully. The differences to your system
are the release of the TCP/IP Runtime System:

    SCO TCP/IP Runtime 1.1.0h	instead of	SCO TCP/IP 1.1.0b

and the configuration of the controller:

    IRQ: 2	instead of	IRQ: 5

You should verify the jumper settings of you controller. The only change
to the factory settings have to be the network cable jumpers. We use the
AUI port and changed therefore only two jumpers.

regards
Dirk Twiehaus

c/o Nixdorf Computer AG
Abt. DX-PC
Pontanusstr
D-4790 Paderborn
FRG