Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!aplcen!uunet!blkcat!f123.n109.z1.fidonet.org!Frank.Mallory
From: Frank.Mallory@f123.n109.z1.fidonet.org (Frank Mallory)
Newsgroups: comp.sys.dec.micro
Subject: Changing port config on Rainbow
Message-ID: <695.25F9E96D@blkcat.fidonet.org>
Date: 11 Mar 90 00:34:16 GMT
Sender: ufgate@blkcat.fidonet.org (newsout1.26)
Organization: FidoNet node 1:109/123 - Little Black Cat, The Black Cat
Lines: 20


 AW> How does one change the printer or comm port configuration to last
 AW> through a power-cycle? Using setport I can configure the port for
 AW> the baud rate, parity, etc, that I need but I can't seem to get them
 AW> to stick. They have to be re-entered everytime the machine is turned
 AW> on. Any suggestions?

Push F3 (Set-up) and then shift-s.  That should save the baud rate and parity,  
but possibly not some of the other settings (e.g., flow control).

                        frank.mallory@blkcat.fidonet.org
 



--  

	Frank Mallory at The Black Cat's Shack (Fidonet 1:109/401)
	Internet:  Frank.Mallory@f123.n109.z1.fidonet.org    
	UUCP:      ...!uunet!blkcat!123!Frank.Mallory