Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!ucbvax!PINE.CIRCA.UFL.EDU!vu2oak
From: vu2oak@PINE.CIRCA.UFL.EDU ("GORUR")
Newsgroups: comp.sys.transputer
Subject: interface LS C with OCCAM
Message-ID: <9003130408.AA25453@devvax.TN.CORNELL.EDU>
Date: 13 Mar 90 03:57:00 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 20

This message is for Mr.Ken Koontz.My message to him bounced ,so I was forced to post it on the net.

Ken,
	Nice to know that i am not alone in the battlefield..given my timeframe
i'd rather be not..
	we have VME 3/2 adaptor to connect B014 on the SUN 3/110.(Advised by 
inmos).My major concern is to have OCCAM and C  running on the system.One of 
our need is to be able to interface OCCAM code with C code..do you have any idea about it..does LS C support such an interface?is there any advantage with
source code over binary version other than better documentation..?
when i talked to Mr. Bailey at LS,i got the impression that LS C compiler is 
supplied on floppy disk rather than tape(for sun application).. i might be wrong
he says he is not sure about the interface question(OCCAM and C).I am confident
of getting the system (1 B014, 1 B404, 3 B411) to run with D505 and D514.
I would appreciate any comments.If i have any further questions, can i call you?
arun
database research center
univ of florida
gainesville,florida
vu2oak@pine.circa.ufl.edu
asg@beach.cis.ufl.edu