Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!uwm.edu!lll-winken!uunet!hacker!steve
From: steve@hacker.UUCP (Stephen M. Youndt)
Newsgroups: comp.unix.i386
Subject: Drivers and Hardware suggestions wanted for Bell Tech Unix S5.3.2u
Keywords: SCSI VGA X11 Tape Backup Bell Tech
Message-ID: <182@hacker.UUCP>
Date: 8 Mar 90 11:52:38 GMT
Organization: H.a.L. Systems, Burke, VA
Lines: 32


	First off let me thank those of you who responded to my posting, 
letting me know that I was, in fact, reaching the outside world.
	Second, having been properly chastized by a gentleman in Stirling, VA
for the length of my posting, I will attempt to be more concise.  I apollogize
in advance if any of these questions are old, but I'm new to Unix and the
net.

	I have:
		Bell Tech Unix System V.3.2u w/ Software development set
	on a 20 MHz AMAX 386 Motherboard w/ 4Mb, MFM controller, ST4096,
	Monochrome adapter.

	I would like:
		The ability to drive a Orchid Prodesigner+ under X11 (VGA
	drivers are not included w/ Bell Tech Unix).  SCSI capability, with
	about a 300Mb drive and a Tape Backup Unit also on the SCSI bus.
	Bell Tech also does not support SCSI, so I need to find drivers for
	that as well.

	Questions:
		Are VGA and SCSI/Tape/Disk drivers readily available for
	Bell Tech Unix, and where can I get them?  Is there a good X11 package 
	that will install under Bell Tech?  What are good SCSI 
	controller/drive/TBU combinations? Is there a better, non-interlaced, 
	card than the Orchid PD+ for the price?

	That's all for now.  Mail answers/comments/questions/etc directly to
me, and I'll summarize if there's interest.  Thanks in advance.

Stephen M. Youndt			uunet!hacker!steve
"Hacker at Large"			VMS System Programmer